Gamma Setting - Panasonic PT-DW100E Operating Instructions Manual

Adjusting the picture (continued)
Press ◄► to switch "COLOR
3.
TEMPERATURE".
• The setting will change as follows each time
◄► is pressed.
DEFAULT
HIGH
• When any setting other than "OFF" has been
selected for colour matching, the COLOR
TEMPERATURE setting is fixed at "USER1".
• "DEFAULT" cannot be selected when the picture
mode has been set to "USER".
To further adjust toward the
desired white balance
4. Select "USER1" or "USER2" in
Step 3.
5. Press ENTER.
• The "WHITE BALANCE" screen will be
displayed.
WHITE BALANCE
WHITE BALANCE HIGH
WHITE BALANCE LOW
Press ▲▼ to select "WHITE
6.
BALANCE HIGH" or "WHITE
BALANCE LOW".
7. Press ENTER.
• The "WHITE BALANCE HIGH (LOW)" screen
will be displayed.
WHITE BALANCE HIGH
RED
GREEN
Press ▲▼ to select "RED",
8.
"GREEN" or "BLUE".
Press ◄► to adjust the level.
9.
Item Operation
Press ►
button.
RED
Press ◄
button.
Press ►
button.
GREEN
Press ◄
button.
Press ►
button.
BLUE
Press ◄
button.
54 – ENGLISH
USER1 USER2
MIDDLE LOW
255
255
Adjustment
Adjustment
range
Maximum
Deepens red.
value
HIGH : 255
Weakens red.
LOW : 127
Deepens green.
Minimum
value
HIGH : 0
Weakens green.
LOW : -127
Deepens blue.
Default
HIGH : 255
Weakens blue.
LOW : 0
Note
• All colours will not be displayed properly unless
adequate adjustment is made. If the adjustment
does not look suitable, you can press DEFAULT to
return the setting for the selected item only to the
factory default setting.
• The colour temperature cannot be adjusted for the
internal test pattern (p. 85). Be sure to project the
input signal when adjusting the colour temperature.

Gamma setting

This switches the gamma mode.
Press ▲▼ to select "GAMMA".
1.
COLOR TEMPERATURE
GAMMA
SHARPNESS
Press ◄► or ENTER.
2.
• The "GAMMA" individual adjustment screen
will be displayed.
GAMMA
CHANGE
Press ◄► to switch "GAMMA".
3.
• The setting will change as follows each time
◄► is pressed.
DEFAULT USER1*
2.6
* "USER1" and "USER2" appear when the setting
was set with a control command from the serial
terminal.
Note
• "DEFAULT" cannot be selected when the picture
mode has been set to "USER".
DEFAULT
DEFAULT
0
DEFAULT
USER2*
2.5 2.2