Using The Remote Control Unit - Panasonic PT-DW10000U Operating Instructions Manual

Using the remote control unit

Loading batteries
When loading supplied AA batteries into the battery
compartment of the Remote Control, make sure that
their polarities are correct.
1. Open battery compartment lid.
Open the lid in the order # and then $.
•
$ $
2. Insert the batteries.
• Into battery compartment, with their polarities
orientated as indicated (
compartment.
Supplied AA batteries Supplied AA batteries
(insert the (insert the
3. Close the battery compartment
lid.
• Replace the battery compartment lid over the
compartment and slide until it clicks.
Attention
• Do not drop the Remote Control unit.
• Do not expose Remote Control unit to any liquid.
• Do not use NiCd batteries.
• Release the LOCK button before operating the
remote control. (p. 13)
# #
, ) in the
+
–
side first). side first).
– –
Effective range of remote
control operation
The Remote Control should normally be aimed at
either the front or rear remote control receiver window
on the projector (figure 1).
The effective control range is approx. 30 metres from
the beam receiver on the front or rear.
Otherwise, it may also be aimed at the screen, which
will reflect commands back to the projector's front
receiver window as illustrated in figure 2.
• When the Remote Control is aimed at the screen,
the effective control range may be reduced due to
the optical loss by screen reflection.
Figure 1
• Top View
(Front) (Front)
30° 30°
Remote Remote
30° 30°
Control Control
• Side View
Remote Remote
Control Control
30° 30° 30° 30°
15° 15°
15° 15°
Remote Remote
Control Control
Figure 2
Screen Screen
Remote Remote
Remote Control Remote Control
Control Control
receiver window receiver window
(front) (front)
(Rear) (Rear)
30° 30°
Remote Remote
30° 30°
Control Control
15° 15°
15° 15°
Remote Remote
Control Control
30° 30° 30° 30°
Remote Remote
Control Control
Projector Projector
Remote Control Remote Control
receiver window receiver window
(rear) (rear)
ENGLISH –
17