Avaya 9601 Administering page 74

Security
Parameter
MYCERTWAIT
MYCERTCAID
SCEPPASSWORD
VLAN
Configure the following VLAN parameters.
Parameter
VLANSEP
L2Q
PHY2VLAN
L2QVLAN
For the above VLAN configuration, there will be a full VLAN separation between the device and
computer packets. The device tries to obtain an IP address from the DHCP server on the voice
VLAN. If the device gets an IP address, the device sends all the tagged packets on the voice LAN.
Set the PHY2VLAN parameter to the data VLAN so that untagged packets from the computer are
assigned to the data VLAN or the tagged packets from the computer are forwarded to the data
VLAN. Tagged packets from computers on VLANs other than the data VLAN are blocked.
Administering Avaya 9601/9608/9611G/9621G/9641G/9641GS IP Deskphones SIP
74
Type Default Description
value
If the renewal time interval has elapsed the phone starts to
periodically contact the SCEP server again to renew the
certificate. The range is from 1 to 99.
Numeric 1 Specifies the behavior of the device when performing
certificate enrolment. assign one of the following values:
• 0: Periodical check in the background
• 1: Wait until a certificate or a denial is received or a
pending notification is received
String CAIdenti Specifies the Certificate Authority Identifier. Certificate
fier Authority servers may require a specific CA Identifier
string in order to accept GetCA requests. If the device
works with such a Certificate Authority, the CA identifier
string can be set through this parameter.
String $SERIA Specifies a challenge password to use with SCEP. The
LNO value of SCEPPASSWORD, if non-null, is included in a
challengePassword attribute in SCEP certificate signing
requests.
If the value contains $SERIALNO, $SERIALNO is
replaced by the value of SERIALNO,. If the value contains
$MACADDR, $MACADDR is replaced by the value of
MACADDR without the colon separators.
Set to Notes
1 Enables the VLAN separation.
0, 1, or 2 Specifies 802.1Q tagging mode.
Non- This is the data VLAN and must not have the same value as the
zero L2QVLAN parameter.
value
Non- This is the voice VLAN and must not have the same value as the
zero PHY2VLAN parameter.
value
Comments on this document? infodev@avaya.com
August 2015