Preparing Appliance For Installation - Valor 940 Installer And Owner Manual

INSTALLER GUIDE

8. PREPARING APPLIANCE FOR INSTALLATION

1. Detach the burner unit from the
convection box by removing two screws
(See figure 12). Lift the burner unit clear.
2. Fit the two "U" section seals to the
bottom edges of the convection box side
flanges (See figure 13).
3. It is important that the grommet
supplied in the loose parts pack is fitted
to the hole in the rear of the convection
Figure 12. Burner attachment points
box.
4. For concealed connection only:
Pierce the grommet to allow the pipe to pass through it.
The grommet should envelop the pipe. If the hole is larger
than the pipe, seal it with tape. Do not pierce the
grommet unless the supply pipe is to pass through it.
5. The 'Icon' fascia is supplied with two port covers. To fit
the port covers unscrew the four cross over port screws
shown in figure 14. Put the port covers in place and refit
the screws previously removed. Ensure that the screws
are tight and that the cross over ports have returned to
their original position. Also check that there are no gaps
between the cross over ports and the surfaces they are
screwed to (See figure 14).
Figure 13. 'U' Seals
Figure 14. Fitting port covers to 'Icon' model.
Page 23
©
GDC Group Ltd. 2011