Fascia Fitting; To Fit The Closure Plate Baffle; To Fit The Fascia - Valor Brava 347 Installation And Owner's Manual

INSTALLER GUIDE

8. FASCIA FITTING

Before continuing with the installation of this appliance it is important that the
information contained on the back pages of the Owner guide is completed.

8.1 To fit the closure plate baffle.

The closure plate baffle is supplied with the
fire and is intended for use where the height
of the closure plate and sealing tape is
greater than 580mm. When using the baffle
the height of the sealing tape and closure
plate can be extended to a maximum
630mm.
1. At the rear top corners of the fascia
there are two screws, one at each side.
2. Loosen the screws but do NOT remove
them.
3. Locate the baffle onto the screws as in
figure 15. The baffle is angled and should
lean towards the rear of the fire.
4. Tighten the screws to secure.
Figure 15. Closure plate baffle location

8.2 To fit the fascia.

1. Place the fascia over the engine. Make
sure that the top rear of the fascia locates
fully into the 'U' shaped notch of the engine
back panel (See figure 16).
2. Fit the control knob firmly on to the
control spindle.
3. Secure the fascia using the two screws
previously removed. There are two holes in
the fascia. Use the bottom hole.
Figure 16. Fascia top location
©
GDC Group Ltd. OCT 2016
Page 26