To Remove The Fascia; To Replace The Control Slide Unit - Valor 940 Installer And Owner Manual

17.4 To remove the fascia.

1. Remove the bottom front cover / fire front casting.
2. Detach the control-linking bar from the control pivot
bracket by removing the knurled screw, which joins
the control linking bar to the control pivot unit (See
figure 49).
3. Remove the two screws (and washers where fitted)
securing the bottom of the fascia to the sides of the
convection box (See figure 50).
4. Make sure that the control linking bar has been
detached (See 2 above). Carefully lift the fascia
upward to clear the upper retaining brackets on the
convection box (See figure 51). Pull the fascia clear
and place carefully aside.
5. Refit in the reverse order. Make sure that the
fascia is properly located over the upper retaining
brackets. See section 12 of this guide for detailed
fitting instructions.

17.5 To replace the control slide unit.

Visage model.
1. Remove the fascia (See section 17.4).
2. Detach the rear baffle
3. Detach the slide unit by removing two screws
securing the plastic slide mechanism to the rear of
the fascia (See figure 52).
4. Replace in the reverse order.
Adorn model.
1. Remove the fascia (See section 17.4).
2. Detach the rear bezel baffle and bezel by
removing the two screws on the bezel baffle
(See figure 52).
3. Detach the slide unit by removing two screws
securing the plastic slide mechanism to the rear
of the fascia (See figure 52).
4. Replace in the reverse order.
Icon model.
1. Remove the fascia (See section 17.4).
2. Detach the slide unit by removing two screws securing the plastic slide mechanism
to the rear of the fascia (See figure 52).
3. Replace in the reverse order.
©
GDC Group Ltd. 2011
INSTALLER GUIDE
Page 42
Figure 49. Control linkage
disconnection
Figure 50. Fascia bottom
location (Shown with Visage
fascia).
Figure 51. Fascia top location