Start Maintenance
Check media wrinkles
1
C H E C K F O R
M E D I A W R I N K L E
Perform start maintenance
1
á R E W I N D
F O R M F E E D â
ß P H . R E C
2
# S T A R T M A I N T E N A N C E
>
Replace the spittoon case/unit
Replace the spittoon case approximately once every three months depending on the amount of dirt on its
surface. If a spittoon unit and a tube set are available when replacing the spittoon case, replace them at the same
time. (The IP7-167 includes one spittoon unit and one tube for four spittoon cases.) Replace also the spittoon
absorber liquid at the same time.
Replace when...
Replace the spittoon case when:
- You find the ink clot accumulated on the spittoon case surface; or
- The net is broken.
When replacing the spittoon case or unit from the operation panel menu, start the procedure from step 1. When
replacing while executing [#START MAINTENANCE], start the procedure in step 4.
You will be prompted to replace the spittoon case or unit during the start maintenance guidance after 3 months
or 2.5 km of print length.
1
á R E W I N D
F O R M F E E D â
ß P H . R E C
74
IP-7900-26/IP-7700-26 Basic Operation Guide
P H . M A I N à
P H . M A I N à
Check that the media is not wrinkled.
If it is wrinkled, either set the media again or feed it up
to an area without wrinkles.
* Printing on wrinkled media may damage the nozzle
surfaces.
Press the
key.
[
#START MAINTENANCE
Execute
guidance for the following maintenance items.
Press the
key to execute an item or the
key to go to the next item.
Press the
key.
]
to display
C AN C EL