Table of Contents
Advertisement
IP-7700 Only
Flange holder
5
Capping unit side
6
7
Wiping unit side
With pressing the media edge
guard's your side part, move each
media edge guard.
8
Take-up side
Pressure control knobs
38
IP-7900-26/IP-7700-26 Basic Operation Guide
Shaft holder
Knob screw
Wiping unit side
Front cover
Protection bar
Capping unit side
Set the flange holder, and close the shaft holder.
After closing the shaft holder, fasten the knob screw.
Remove the protection bar and open the front
cover.
Move the media edge guards to each side.
Move the media edge guards to each side so that they
are not under the media.
With pressing the media edge guard's your side part,
move each media edge guard.
CAUTION
- Be sure to press the media edge guard on your side
when moving the media edge guards. You may get
injured if you strongly press the plate's edge while
moving the media edge guard.
Set the pressure to "Open" by rotating the
pressure control knob.
At this step, by pressing and holding the MENU key,
the Printer enters the offset mode, in which the media
is loaded with the slide in the direction to the wiping
unit.
After "USE OFFSET MODE" is displayed on the
operation panel, select a key from the two below.
-
key, to set the offset mode to ON; or
-
key, to set the offset mode to OFF
CA N CE L
Offset mode requires ...
- To load the media in the offset mode, an
optional offset loading kit 104 or 74 is required.
Advertisement
Table of Contents
