Table of Contents
Advertisement
Before starting the second-side printing...
- Go to the operation panel and change the settings of [#SUCTION FAN LEVEL] in accordance with the used
media. If the media tends to stick easily, set [#SUCTION FAN LEVEL] to [LOW].
During second-side printing, the Printer operates in [FWD ONLY] regardless of the [#MEDIA ADV MODE]
setting.
Suction fan: [LOW]
# S U C T I O N F A N L E V E L
> 0 1 : L O W
To avoid the irregular media advance, set the
suction fan's vacuum pressure to low.
7
Paper feeder
CAUTION
- The slanted or wrinkled media may cause media jam or
skew.
8
Reference solid line
Cutter groove
9
Take-up side
Pressure control knob
66
IP-7900-26/IP-7700-26 Basic Operation Guide
Insert the top edge of the media into the Printer.
With extending the media to eliminate the media
wrinkle, insert the media end into the paper feeder.
If the media is curled
- If it is hard to insert the media end into the
Printer rear
Align the reference solid line with the cutter
groove position.
If the line is not aligned at the right and left sides, align
it at one side first and hold the position by hand, and
then align them at the other side while pulling the
media.
Set the pressure control knob to "Normal".
Suction fan
Media
paper feeder due to a curl of the media,
interpose an interleaf and insert the media
end under the interleaf as shown in the figure
below.
- Upward curl
- Downward curl
Advertisement
Table of Contents
