Turn The Printer On - Oki IP-7900-26 Operation Manual

Turn the Printer on


With the procedure below, supply the power to the Printer's two 200V power system.
CAUTION
- Do not use any power cable other than those supplied with the Printer.
- The supplied power cables are for 200 VAC only. Note that the plug shape differs from that for 100 VAC.
- Be sure to secure the power cables with cable clamps. Otherwise, they may be caught by the feed unit resulting in
electric shock or damage to the Printer.
Turn the printer power and heater power switches on only before your first operation. From the next operation, turn the
Printer on and off only by pressing the POWER switch on the operation panel.
Switch off (O)
1
2
Printer power switch + Printer power inlet
Heater power switch + Heater power inlet
Power inlet
Supply side
With the two power cords supplied with the
Printer, connect the Printer's two power inlets
and the power supply's two sockets.
Be sure to confirm that at the rear of the Printer the
printer power switch and heater power switch are set
to off, the side marked with O.
Clamp the two power cords to the Printer.
To protect the power cords, be sure to clamp them.
33