Oki IP-7900-26 Operation Manual page 39

9
Paper feeder
10
11
Insert the media end into the paper feeder,
while smoothing out the media by hand to prevent
wrinkles.
Printer rear
Feed the media for 1m more after the blip.
In this state, smooth out the media toward the both
sides on the platen to make the media center tense.
Platen
Feed back the media.
Feed back the media while pressing the center of the
media gently at the supply side.
Confirm that the front media edge precedes the
closed front cover by approx. 30 cm.
If the media is curled
- If it is hard to insert the media end into the
paper feeder due to a curl of the media,
interpose an interleaf and insert the media
end under the interleaf as shown in the figure
below.
- Upward curl - Downward curl
Point to be checked
- If the media is set with a distortion or wrinkles,
it may cause a media jam or skew.
Front cover
30cm
Important!
- This step is important to set the media properly.
- IP-7700 only
Feed the media back while drawing the flange
to the right direction (right side in the figure on
the left).
39