Installation
CAUTION
− Turn off the power switch of the printer before installing the footswitch.
Plug the other connector of the footswitch in the connector of the
take-up reel unit, and then screw the ground line.
Loosen the screw fixing the cable clamp to the printer. Then fix the cable with
the cable clamp at the clamp's original position.
Scroller (IP7-015)
An optional scroller available for both the roll feed unit and take-up reel unit
Scroller flange (IP7-018)
An optional scroller flange
Scroller set (IP7-019)
An optional scroller flange <2> and scroller shaft <1>
Tensioner 104 (IP7-023)
Tensioner 74 (IP7-022)
An optional kit to print on the lightweight banner
Offset loading kit 104 (IP7-025)
Offset loading kit 74 (IP7-024)
An optional kit to install media with the slide to the wiping
unit direction
Flange shaft fixture (IP7-168)
Flange shaft fixture that can be used on both the supply side and the take-up side
scrollers.
132
IP-7900-26/IP-7700-26 Basic Operation Guide
Ground line
Cable clamps