Oki IP-7900-26 Operation Manual page 47

6
Tape
Points to be noted on winding media
- If the media is not installed straight to the paper tube, a skew of media may occur.
- When the take-up direction is set as Inner take-up, the taken-up media's diameter increases and the media
cannot backfeed after printing. Select [FWD ONLY] beforehand in MEDIA BACK MODE of MEDIA REG MENU.
(When the media backfeeds in [BACK&FWD] mode, the motor idles and may cause a trouble.)
7
8
9
Attach the media passed through the Printer to
the paper tube.
(1) Check the take-up direction, remove the slack of the
Paper tube
(2) Attach the media to the paper tube with adhesive
Set the take-up direction switch according to
Take-up direction switch
the take-up direction.
 Outer take-up
- OFF
OFF
 Inner take-up
By pressing the
wind one full turn of the media on the paper
tube.
Again set the take-up direction switch to OFF.
Take-up direction switch
OFF
OFF
media, and then make sure that the media position
is not deviated on the supply side and the take-up
side.
tape. Tape it first at the center, and then at the right
and left sides, so that the tension is uniform across
the media width and that no wrinkles are found on
the media. The taped positions are recommended to
be three or more in total.
Inner take-up: Outer take-up:
Media is taken up with its print Media is taken up with its print
surface coming inside. surface coming outside.
key feed the media, and
F E E D I N G M E D I A
CAUTION
- If the tension bar is attached without winding the
media by one turn, the tape will peel off.
47