Oki IP-7900-26 Operation Manual page 35

Load a roll media onto the scroller flange and scroller shaft.
2
CAUTION
- Do not grab this roll
spacer as it has several
protrusions.
Insert the scroller into the paper tube,
determine the distance between the
media edge and the ange.
Flange
Attach the paper setting gauge's
ange side to the ange's spoke
side.
Rotate the handle clockwise as far as it
will go, and then secure the scroller at
the point.
Handle
Roll spacer
Claw
CAUTION
– Do not touch the claw of the
scroller.
Remove the two screws and move the roll spacer to the center of the media. There
are three screwing positions.
Scroller
Do not move this roll
spacer.
For outer take-up mode
For inner take-up mode
Paper setting
gauge
Scroller
Roll spacer
The roll spacer prevents the paper
tube from bending at the center
due to the media weight.
Move it when using media that
tends to bend (100-inch media,
etc.).
Move it also if it comes in the way
of the flange spacer used with
media short in width.
Flange spacer
Roll media
Roll media
Knob
(3)
(1) The ange spacer has teeth. Push it as far as it will go.
(2) Match the ange stopper with the claw of the ange
spacer
CAUTION
- Hold the knob to move the ange stopper. Holding
another part to move the ange stopper may lead to
injuries.
(3) Tighten the knob to secure the ange spacer and the
ange stopper.
Flange stopper
(1)
(2)
35