Oki IP-7900-26 Operation Manual page 40

12
Supply side
13
(1)
With pressing the media
edge guard's your side part,
move each media edge
guard.
14
15
C H E C K E D G E G U A R D
[ O K ?
16
S E L E C T M E D I A
R O L L / S H E E T : R O L L
40
IP-7900-26/IP-7700-26 Basic Operation Guide
Set the pressure to "Normal" by rotating the
pressure control knob counterclockwise.
Set the media edge guards.
(1) With pressing the media edge guard's your side part,
(2) Align each media edge guard's notch to the media
Check that the media edge guards are not under the
media or thick media is not caught by having been
inserted forcibly.
Notch
(2)
Align each media edge
guard's notch to the media
edge.
Close the front cover, and set the protection
bar.
Press the
Press the
Point to be checked again
- Check that the media on the platen has no
wave or wrinkle.
move each media edge guard to the media edge.
edge.
CAUTION
- The print operation without media edge guards may
cause a media jam.
- Be sure to press the media edge guard on your side
when moving the media edge guards. You may get
injured if you strongly press the plate's edge while
moving the media edge guard.
key.
key.