CHAPTER 4: USING THE METER
4.3.4
Configuring the CT Setting
EPM 6000 MULTI-FUNCTION POWER METERING SYSTEM – USER GUIDE
The
message will appear and the meter will reset.
Stor ALL donE
Use the following procedure to program the CT setting.
Push the DOWN Button to scroll through the configuration mode
parameters.
Press ENTER when
is the active parameter (i.e. it is in the "A" screen and flashing).
Ct
This will display the and the
Press ENTER again to change to display the
screen.
The
value is preset to a 1 or 5 A at the factory and cannot be changed.
Ct-d
(CT numerator) screen.
Ct-n
(CT denominator)
Ct-d
4–11