3. In the Select Controller dialog, go to the drop down box near the top and select Do not scan
serial ports.
Click Scan to search for the NextMove ES.
When the search is complete, click 'NextMove ES' in the list to select it, then click Select.
Note: If the NextMove ES is not listed, check the USB or serial cable between the
NextMove ES and the PC. Check that the NextMove ES is powered correctly, and
has completed its startup sequence (indicated by the node number being displayed
by the Status display). Click Scan to re-scan the ports.
4. A dialog box may be displayed to tell you that Mint WorkBench has detected new firmware.
Click OK to continue. Mint WorkBench reads back data from the NextMove ES. When this
is complete, Edit & Debug mode is displayed. This completes the software installation.
Servo Systems Co. • 115 Main Road • P.O. Box 97 • Montville, NJ,
6-8 Operation
07045-0097 • (973) 335-1007 • Toll Free: (800) 922-1103
Fax: (973) 335-1661 • www.servosystems.com
www.baldormotion.com
MN1928