Measured Value Correction And Compensation - Ahlborn ALMEMO 710 Operating Instructions Manual

Below the measured value the functions - range, maximum and minimum val-
ues (s. XREF) - are still available; and these can also be used. Below the
measured value, if it is compensated in terms of some other value, the com -
pensation values in question also appear.
By means of the ´Channel parameters´ tab all the parameters for the
channel in question can be viewed over 4 pages and directly modified.
The following table lists the functions and section references:
13.2.1
13.2.2
13.2.4
10.1.3.1
13.2.13.7
13.2.6
13.2.7
13.2.8
13.2.8
13.2.9
13.2.11
13.2.10
13.2.12
13.2.5.1
13.2.13
13.2.10
Alternatively, the individual ´Channel functions´ (see 13.2) can also be found
bottom right via the ´Channel functions´ option and the appropriate heading..

12.2 Measured value correction and compensation

To achieve maximum measuring accuracy the zero-point of the sensors can
be corrected in all menus at the touch of a button. By entering a setpoint the
correction value will be automatically calculated and stored in the sensor con-
nector. For sensors affected by ambient temperature or atmospheric pressure
the appropriate compensation can then be provided.
Measuring by means of a measuring channel
Averaging in progress
Output function active: Diff, Hi, Lo, M(t), Alarm (s. 13.2.5.1)
Temp. compensation CT active: Value, fixed, measured
Atm. pressure compensation CP active; Value, fixed, measured
Channel designation
Measured value smoothing
Averaging mode
Cycle factor
Minimum sensor supply voltage
Locking level
Limit values, maximum and minimum
Actions, maximum and minimum
Relays, maximum and minimum
Analog output start / end
Base value, factor, decimal point shift
Zero-point and gain
Units
Output function
Measuring range with reference channel and multiplexer
Calibration offset and calibration factor
ALMEMO ® 710 41