Function Keys; Status Leds; Status Symbols - Ahlborn ALMEMO 710 Operating Instructions Manual

9.3 Function keys

For the purpose of controlling measuring operations there are just a few super-
ordinate keys located along the bottom edge of the screen.

9.4 Status LEDs

The status LEDs (5) report the current device status as follows :
ON
SLEEP flashes briefly just once Device is in sleep mode.
CHARGE
START is lit continuously Cyclic measuring has started.
lights up briefly
REC is lit continuously Cyclic measuring channel scan with data saving
flashes
lights up briefly
COM is lit continuously Cyclic measured value transmission to PC
flashes
lights up briefly
ALARM
ALARM flashes
LOCKED

9.5 Status symbols

Battery status and memory status are displayed on the far right of the top
line.
Battery charge status full/normal/almost empty/being recharged
Memory status empty / normal / almost full
By touching on the appropriate symbol the exact status
can be viewed in the associated menu..
To start a cyclic measuring operation see 10.4
To stop a cyclic measuring operation
Once-only manual output / saving of all measured values
Call up settings for local menu
key in the menu
If applications occupy more than one page, the arrow keys
can be used to access the current page.
Device is switched ON.
Device's batteries are being recharged.
Once-only measuring channel scan
This also lights up during output from memory.
Data saving at scan cycle
Once-only measuring channel scan with data saving
Measured value transmission to PC at scan cycle
Once-only measuring channel scan transmits data to PC
Limit value infringement or sensor breakage
Supply voltage to device too low
Key operation is restricted by block function.
Function keys
ALMEMO ® 710 23