Declaration Of Conformity - Ahlborn ALMEMO 710 Operating Instructions Manual

transmission is still not possible, unplug all networked devices and
check all devices individually using the data cable to the computer
(see above); Check the wiring for short-circuit or crossed wires. Are
all network distributors supplied with power? Network the devices
again one at a time and check successively (see above)
If, after performing the above-listed checks and remedial steps, a device still
fails to behave as described in the operating instructions, it must be returned to
our factory in Holzkirchen, accompanied by a brief explanatory note, error de-
scription, and if available test printouts. With the ALMEMO
you can print out screenshots showing the relevant programming details and
save and / or print out a comprehensive ´Function test´ in the device list or ter-
minal mode.

16. DECLARATION OF CONFORMITY

Ahlborn Mess- und Regelungstechnik GmbH declares herewith that measuring
instrument ALMEMO
quirements of EU directives relating to low voltage and to electromagnetic
compatibility (EMC) (89/336/EWG).
The following standards have been applied in evaluating this product.
Safety EN 61010-1:2011
Electromagnetic compatibility (EMC)
If a product is modified in any manner not agreed with us in advance, this dec-
laration becomes void.
When using the sensor with an extension care must be taken to ensure that
wiring is not laid alongside or close to high-voltage power cables and that it is if
necessary properly shielded so as to prevent spurious interference being in-
duced in the system.
The following advisory notes must be observed when operating the device :
Using the device in strong electromagnetic fields may aggravate measuring er-
rors. After exposure to such irradiation ceases, the device will again operate
within its technical specifications..
710 carries the CE label and complies in full with the re-
®
EN 61326-1:2013
ALMEMO
Trouble-shooting
Control software
®
® 710 75