Sam4s ER-230 Operation And Program Manual

!
Before You Start
Please locate the
following items:-
1 x Paper Rolls.
1 x Operation and
Program Manual.
1
To Install Till Roll
• Plug the power cord of the cash register into
the AC outlet (plug socket).
• Remove the printer cover (A)(B).
• Push the Yellow lever to release the printer
mechanism. (C).
• Ensure that the paper roll is being fed from the
bottom of the roll (E).
• Feed the leading edge of the paper roll through
the paper slot (D).
• Pass the leading edge of the roll of paper
through the cutter slot on the printer cover,
tear off the excess paper, close the paper
mechanism lever and replace the printer
cover (F).
2
Entering a Basic Sale
The cash register has PLU buttons 1-12 through which to register
your sales. The purpose of these are to assist you in analysing
your business. (For example PLU 1 could be used for entering
'Food' and PLU 2 could be used for 'Non-Food' etc.) By pressing
the appropriate PLU button and registering your sale you will
begin to analyse your sales ready for the end of the day report.
• Press the MODE key until the display shows a line over the REG position.
• Press the PLU key on the keyboard (i.e. 1 ) if the button has a preset price or
• Enter an amount on the numeric keypad. (For example, for £2.99, enter: 299).
Do not use the decimal key and press the PLU key on the keyboard (i.e. 4 )
• To enter another sale repeat as above.
• Press the SUBTOTAL button to show the value due.
• If you would like to calculate change, enter the value of money given to you by the customer.
Do not use the decimal key. (For example, for £10.00 enter: 1000).
• If you do not wish for the change due to be displayed then go on to the next stage.
• Press the CASH/TEND button to open the drawer.
• If the money given has been entered, then the change will be displayed.
Model ER-230 Model ER
!
Battery Information.
The ER-230 register runs on Mains power or its internal battery power.
The register can run for 8hrs on a single charge. It is important to note the
following points regarding the battery:-
• Prior to initial operation the battery should be charged for 15 hours in
a well ventilated area.
• The battery should not be fully discharged, and if this occurs should be
charged immediately.
• To charge the battery from flat will take in excess of 15 hours, therefore
regular charging is advisable.
• The battery can be charged with the register in the off or on mode.
RPT RPT
VOID VOID OFF REG OFF REG
-230
A M O U N T A M O U N T
X Z P S BAT BAT