Load Or Change The Receipt Paper - CognitiveTPG A799 User Manual

Tpg a799 two-color thermal receipt printer
Hide thumbs Also See for A799:
Table of Contents

Advertisement

12
Chapter 3: Setting up the Printer

Load or change the receipt paper

Caution: You must use qualified paper rolls with TPG printers. The list of qualified paper is in Chapter 5. Using
unqualified paper may void the warranty.
You will later use the same procedure to change the receipt paper as you will to load it during installation. The minor
difference is noted in the directions below.
If you are installing the printer using the wall mount kit, you may find it easier to load the paper roll after installation.
Note: The printer must be set to the paper type being used for proper operation. This can be done by sending the command
1D 81 m n or by a selection in the configuration menu. To change the paper type in the configuration main menu select
"Set Paper Type" and make selections. (See page 21 for how to enter the configuration menu.)
1 Open the receipt cover by pushing up evenly on each side of the cover until it unsnaps (1).
2 Loading: Remove the test printout (2) and starter roll. Slide the supports off the roll (3).
Changing: Remove the used paper roll.
3 Tear a clean edge on the new receipt paper roll, making sure the tape has been completely removed.
4 Place the receipt paper into the paper compartment so it unrolls from the bottom (4). Leave a few inches of paper
sticking out of the printer.
5 While holding the paper in place, close the receipt cover (5). To test that the paper is loaded correctly, advance the
paper with the paper feed button.
Note: If the paper jams, make sure the roll is inserted correctly. Check the illustration above for proper orientation.
6 Tear the excess paper off against the blade in the cover (6).
A799 Two-Color Thermal Receipt Printer: User Guide
1
4
A799-UG00001 Rev. C
6
12/08

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Colorpos a799

Table of Contents