Table of Contents
Advertisement
26
Chapter 5: Advanced EZ-LP Features
Making Configurations Changes Using DOS Commands
1. Power off your current desktop label printer and disconnect the
communication cable.
2. Connect Power supply to EZ-LP and plug into wall. Do NOT turn on EZ-LP at
this time.
3. Connect preferred interface cable to EZ-LP and connect to PC.
4. Turn on the EZ-LP printer.
5. Open a text file editor such as Notepad; START > All Programs > Accessories >
Notepad.
6. Type in the desired code (see examples below) and save the file. Note this file
should be saved on the root C:\ directory.
The example below shows the code to shift the printed image left by 0.50 inches.
The 50 represents the amount of shift desired in hundredths of an inch and can be
changed to another amount.
For additional setting adjustment codes, please contact technical support or reference
the CPL Programmer's Guide at www.CognitiveTPG.com.
Click START > Run then type "cmd" and click "OK"
7. Type in one of the COPY commands below depending on the communication
interfaced used. The examples show "filename.txt" which represents the file
name of the txt file created in step 2.
Advertisement
Table of Contents
