Memory Position Recall - Jeep CHEROKEE 2016 Owner's Manual

164 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
NOTE: Before programming your RKE Key Fob you
must select the "Memory To FOB" feature through the
Uconnect system screen. Refer to "Uconnect Settings" in
"Understanding Your Instrument Panel" for further in-
formation.
To program your RKE Key Fob, perform the following:
1. Cycle the vehicle's ignition to the OFF position.
2. Select the desired memory profile 1 or 2.
NOTE: If a memory profile has not already been set, refer
to Programming The Memory Feature in this section for
instructions on how to set a memory profile.
3. Push and release the SET button on the memory
switch, then within five seconds push and release the
button labeled 1 or 2 accordingly. "Memory Profile
Set" (1 or 2) will display in the EVIC/DID.
4. Push and release the LOCK button on the RKE Key
Fob within 10 seconds.
NOTE: Your RKE Key Fob can be unlinked to your
memory settings by pushing the SET (S) button, followed
by pushing the UNLOCK button on the RKE Key Fob
within 10 seconds.

Memory Position Recall

NOTE: The vehicle must be in PARK to recall memory
positions. If a recall is attempted when the vehicle is not
in PARK, a message will display in the EVIC/DID.
To recall the memory settings for driver one, push
MEMORY button number 1 or the UNLOCK button on
the RKE Key Fob linked to memory position 1.
To recall the memory settings for driver two, push
MEMORY button number 2 or the UNLOCK button on
the RKE Key Fob linked to memory position 2.