Memory Position Recall; Seats - Jeep H6 Manual

23_H6_OM_EN_IN_t.book Page 34
34 GETTING TO KNOW YOUR VEHICLE
To program your key fob, perform the following:
1. Place the vehicle's ignition in the OFF
position.
2. Select the desired memory profile (1) or (2).
3. Push and release the set (S) button on the
memory switch, then within five seconds push
and release the button labeled (1) or (2)
accordingly. "Memory Profile Set" (1 or 2) will
display in the instrument cluster display.
4. Push and release the lock button on the key
fob within 10 seconds.
NOTE:
Your key fob cannot be unlinked from your memory
settings. To change the memory settings, overwrite
the set memory programmed to the key fob by
repeating the steps for linking.
M P R
EMORY OSITION ECALL
NOTE:
The vehicle must be in PARK to recall memory posi-
tions. If a recall is attempted when the vehicle is
not in PARK, a message will display in the
instrument cluster display.
To recall the memory settings for driver one or two,
push the desired memory button number (1 or 2)
or the unlock button on the key fob linked to the
desired memory position.
A recall can be canceled by pushing any of the
memory buttons (S, 1, or 2) during a recall. When
a recall is canceled, the driver seat will stop
moving. A delay of one second will occur before
another recall can be selected.

SEATS

Seats are a part of the Occupant Restraint system
of the vehicle.
WARNING!
It is dangerous to ride in a cargo area, inside

or outside of a vehicle. In a collision, people
riding in these areas are more likely to be seri-
ously injured or killed.
Do not allow people to ride in any area of your

vehicle that is not equipped with seats and
seat belts. In a collision, people riding in these
areas are more likely to be seriously injured or
killed.
Be sure everyone in your vehicle is in a seat

and using a seat belt properly.