Programmable Motion End Criterion (Sw 5.1 And Higher) - Siemens sinumerik 840d Programming Manual

Special Motion Commands
5

5.9 Programmable motion end criterion (SW 5.1 and higher)

840D 840D
NCU 571 NCU 572
NCU 573
5.9

Programmable motion end criterion (SW 5.1 and higher)

Programming
FINEA[<axis>]
COARSEA[<axis>]
IPOENDA[<axis>]
Explanation of the commands
FINEA
COARSEA
IPOENDA
Axis
Function
Similar to the block change criterion for continuous-
path interpolation (G601, G602 and G603), the end
of motion criiterion can be programmed in a part
program for single axis interpolation or in
synchronized action for the command-/PLC-axes.
Depending on the end of motion criterion set, part
program blocks or technology cycle blocks with
single axis motion
take different times to comlete.
The same applies for PLC-positioning statements
via FC15/ 16/ 18.
System variable $AA_MOTENDA
The set end of motion criterion can be polled using
the system variables $AA_MOTENDA[<axis>].
•
$AA_MOTENDA[<axis>] = 1
•
$AA_MOTENDA[<axis>] = 2
•
$AA_MOTENDA[<axis>] = 3
Additional notes
The last programmed value is retained after RESET.
References:
5-188
810D 840Di
CCU 2
Motion end when "Exact stop FINE" reached
Motion end when "Exact stop COARSE" reached
Motion end when "Interpolator-Stop" reached
Channel axis name (X, Y, ....)
/FB1/V1 feedrates
Motion end with "Exact stop fine"
Motion end with "Exact stop coarse"
End of motion with "IPO-Stop".
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) − 04.00 Edition
04.00
5
 Siemens AG 2000. All rights reserved