Siemens sinumerik 840d Programming Manual page 78

Flexible NC Programming
1
1.15 Axis transfer, spindle transfer
840D 840D
NCU 571 NCU 572
NCU 573
An axis accepted with GET remains assigned to this
axis even after a key or program reset. When a
program is started the transferred axes or spindles
must be reassigned in the program if the axis is
required in its original channel.
It is assigned to the channel defined in the machine
data on POWER ON.
Direct axis transfer: GETD
An axis is taken directly from another channel with
GETD (GET Directly). This means that no matching
RELEASE has to be programmed in another
channel for this GETD. It also means that other
channel communication has to be established
(e.g. wait markers).
1-78
810D 840Di
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) − 04.00 Edition
02.98
1
 Siemens AG 2000. All rights reserved