Siemens sinumerik 840d Programming Manual page 504

Tables
15
15.1 List of instructions
SETDNO Set D number of tool (T) and its cutting edge to new
SETINT Define which interrupt routine is to be activated when
an NCK input is present
SETM Set one/several markers for channel coordination
SETMS Switch back to master spindle programmed in machine
data
SETMS(n) Spindle n must act as master spindle
SETPIECE Set piece number for all tools assigned to the spindle.
SF Start point offset for thread cutting (spline
offset)
SIN Sine (trigon. function)
SOFT Soft axis acceleration
SOFTA Switch on soft axis acceleration for the programmed
axes
6
SON Nibbling ON (stroke ON)
6
SONS Nibbling ON in IPO cycle (stroke ON slow)
1
SPATH Path reference for FGROUP axes is length of arc
SPCOF Switch master spindle or spindle (n) from speed control
over to position control
SPCON Switch master spindle or spindle (n) from position
control over to speed control
1,6
SPIF1 High-speed NCK inputs/outputs for punching/nibbling
byte 1 (stroke/punch interface 1)
6
SPIF2 High-speed NCK inputs/outputs for punching/nibbling
byte 2 (stroke/punch interface 2)
SPLINE Define spline grouping
7
PATH
1,6
SPOF Stroke OFF, punching, nibbling OFF (stroke/punch
OFF)
6
SPN Number of path sections per block
(stroke/punch number)
6
SPP Length of a path section
(stroke/punch path)
SPOS Spindle position
SPOSA Spindle position across block boundaries
SQRT Square root; arithmetic function
15-504
Edge 0 is
evaluated → 1
Machining in the
local channel is not
influenced by this.
Without spindle
number: Valid for
master spindle
0.0000, ...,
359.999°
Real
see /FB/, N4:
Punching and
Nibbling
see /FB/, N4:
Punching and
Nibbling
Max. of 8 axes
Integer
Integer
Real
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
12.98
SPCON
SPCON (n)
SPCON
SPCON (n)
SPOS=10 or SPOS[n]=10
SPOSA=5 or SPOSA[n]=5
 Siemens AG 2000. All rights reserved
15
m
m 21
m 35
m 35
m 45
m 38
m 38
m 35
s
m
m
m