Set Final D Numbers To Invalid - Siemens sinumerik 840d Programming Manual

04.00
8
8.7 Free assignment of D numbers, cutting edge number CE
840D
NCU 572
NCU 573

8.7.4 Set final D numbers to invalid

Programming
DZERO
Explanation
DZERO
Function
The command is used for support during upgrading.
Offset block marked in this way are no longer
checked by the language command CHKDNO.
To regain access, you must set the D number to
SETDNO again
 Siemens AG 2000. All rights reserved
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) − 04.00 Edition
840Di
Marks all D number of the TO unit as invalid
Tool Offsets
8
8-295