Where To Go From Here - Motorola P-7131N-FGR Product Reference Manual

This guide provides configuration and setup in formation for the ap-7131n-fgr model access point.
Table of Contents

Advertisement

3-18
Motorola Solutions AP-7131N-FGR Access Point Product Reference Guide
configure the parameters of the test. The WNMP ping test only works with Motorola Solutions MUs.
Only use a Motorola Solutions MU to test access point connectivity using WNMP.
NOTE Before testing for connectivity, the target MU needs to be set to the same
To ping a specific MU to assess its connection with an access point:
1. Select
Status and Statistics
2. Select the
3. Define the following parameters for the test.
Station Address
Number of pings
Packet Length
4. Click the
Refer to the Number of Responses value to assess the number of responses from the MU
versus the number of ping packets transmitted by the access point. Use the ratio of packets
sent versus the number of packets received the link quality between the MU and the access
point.
Click the

3.4.5 Where to Go from Here?

Once basic connectivity has been verified, the access point can be fully configured to meet the needs
of the network and the users it supports. Refer to the following:
• For detailed information on access point device access, SNMP settings, network time,
importing/exporting device configurations and device firmware updates, see
Chapter 4, System Configuration on page
ESSID as the access point. Since WPA2/CCMP has been configured for
the access point, the MU also needs to be configured for WPA2/CCMP
and use the same keys. Ensure the MU is associated with the access point
before testing for connectivity.
->
Echo Test
button from within the
The station address is the IP address of the target MU.
Refer to the MU Stats Summary screen for associated MU
IP address information.
Defines the number of packets to be transmitted to the
MU. The default is 100.
Specifies the length of each packet transmitted to the MU
during the test. The default length is 100 bytes.
Ping
button to begin transmitting packets to the specified MU address.
OK
button to exit the Echo Test screen and return to the MU Stats Summary screen.
MU Stats
from the menu tree.
MU Stats Summary
4-1.
screen.

Advertisement

Table of Contents
loading

Table of Contents