Configuring Snmp Rf Trap Thresholds - Motorola P-7131N-FGR Product Reference Manual

System Cold Start
Configuration
Changes
Rogue AP Detection
AP Radar Detection
WPA Counter
Measure
MU Hotspot Status
VLAN
LAN Monitor
6. Click Enable All
7. Click Disable All
8. Click Apply to save any changes to the SNMP Traps screen. Navigating away from the
screen without clicking the Apply button results in all changes to the screen being lost.
9. Click Undo Changes
settings displayed on SNMP Traps screen to the last saved configuration.
10. Click Logout
confirming the logout before the applet is closed.

4.6.4 Configuring SNMP RF Trap Thresholds

Use the SNMP RF Trap Threshold
radio and associated MU performance. SNMP RF Traps are sent when RF traffic exceeds defined
limits set in the RF Trap Thresholds
for the access point, WLAN, selected radio and the associated MU.
To configure specific SNMP RF Traps on the access point:
1. Select System Configuration
the menu tree.
Generates a trap when the access point re-initializes while
transmitting, possibly altering the SNMP agent's configuration or
protocol entity implementation.
Generates a trap whenever changes to the access point's
configuration file are saved.
Generates a trap if a Rogue AP is detected by the access point.
Generates a trap if an AP is detected using a form of radar
detection.
Generates a trap if an attack is detected against the WPA Key
Exchange Mechanism.
Generates a trap when a change to the status of MU hotspot
member is detected.
Generates a trap when a change to a VLAN state is detected.
Generates a trap when a change to the LAN monitoring state is
detected.
button to enable all traps.
button to disable all traps.
(if necessary) to undo any changes made. Undo Changes reverts the
to securely exit the access point Access Point applet. A prompt displays
screen as a means to track RF activity and the access point's
field of the SNMP RF Traps screen. Thresholds are displayed
- > SNMP Access
System Configuration
- > SNMP RF Trap Thresholds
4-39
from