Led Indicators - Motorola P-7131N-FGR Product Reference Manual

2-18 Motorola Solutions AP-7131N-FGR Access Point Product Reference Guide
The Power Injector receives power as soon as AC power is applied. For more information
on using the Power Injector, see
For standard 48-Volt Power Adapter (Part No. 50-14000-247R) and line cord installations:
a. Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the network data supply (host)
and the access point's GE1/POE port.
b. Verify the power adapter is correctly rated according the country of operation.
c. Connect the power supply line cord to the power adapter.
d. Attach the power adapter cable into the power connector on the access point.
e. Plug the power adapter into an outlet.
15. Verify the behavior of the LEDs. For more information, see
16. Place the ceiling tile back in its frame and verify it is secure.
The access point is ready to configure. For information on an access point default
configuration, see
configurations, see

2.8 LED Indicators

An AP-7131N-FGR model access point has six LEDs on the top of the access point housing, and one
optional LED light pipe at the bottom of the unit. However, an AP-7131N-FGR model access point does
not use LED 6, as no third radio is available. Five LEDs illuminate (on top of the housing) for dual radios
models.
The access point utilizes two (different colored) lights below each LED. Only one light displays within
a LED at any given time. Every light within each LED is exercised during startup to allow the user to
see if an LED is non-functional. The LEDs turn on and off while rotating around in a circle. Since two
LEDs feed each light pipe, the pattern is from left to right, then right to left.
NOTE LED blink rate is proportional to activity. The busiest traffic corresponds
Power Injector System on page
Getting Started on page
System Configuration on page
to the fastest blink, while the slowest traffic corresponds to slowest
blink.
LED Indicators on page
3-1. For specific details on system
4-1.
2-6.
2-18.