Table of Contents
Advertisement
6-28
Motorola Solutions AP-7131N-FGR Access Point Product Reference Guide
Notice the status displays "NOT_ACTIVE". This screen automatically refreshes to get the
current status of the VPN tunnel. Once the tunnel is active, the IKE_STATE changes from
NOT_CONNECTED to SA_MATURE.
19. On AP #2, repeat the same steps as above. However, replace AP #2 information with AP #1
information.
20. Once both tunnels are established, ping each side to ensure connectivity.
6.7.2 Configuring Manual Key Settings
A transform set is a combination of security protocols and algorithms applied to IPSec protected
traffic. During security association (SA) negotiation, both gateways agree to use a particular
transform set to protect data flow.
A transform set specifies one or two IPSec security protocols (either AH, ESP, or both) and specifies
the algorithms to use for the selected security protocol. If you specify an ESP protocol in a transform
set, specify just an ESP encryption transform or both an ESP encryption transform and an ESP
authentication transform.
When the particular transform set is used during negotiations for IPSec SAs, the entire transform set
(the combination of protocols, algorithms, and other settings) must match a transform set at the
remote end of the gateway.
Use the
Manual Key Settings
To configure manual key settings for the access point:
1. Select
Network Configuration
2. Refer to the
click the
screen to specify the transform sets used for VPN access.
VPN Tunnel Config
Manual Key Settings
->
WAN
->
VPN
from the access point menu tree.
field, select the
Manual Key Exchange
button.
radio button and
Advertisement
Table of Contents
