Led Indicators; Wing 4.X Led States; Wing 5.X Led States - Motorola AP650 Installation Manual

Installation Guide

2.9 LED Indicators

Both the Integrated Antenna model and the External Antenna model have LED activity indicators on the front of the
case for use with wall mount. With the External Antenna model unit mounted above a ceiling, LEDs are at the
center of an oval badge on the ceiling; a light pipe enables viewing the back LEDs through the ceiling tile.
The LEDs provide a status display indicating error conditions, transmission, and network activity for the 5 GHz
802.11a/n (amber) radio or the 2.4 GHz 802.11b/g/n (green) radio.
The LED behavior is determined by the version of WiNG software running on the controller which the Access Point
is connected to. The tables below show the LED patterns for WiNG 4.x and WiNG 5.x.

2.9.1 WiNG 4.x LED States

Task
Unadopted Blinking at 5Hz
Normal If this radio band is enabled:
Operation Blink at 5 second interval
If this radio band is disabled:
Off
If there is activity on this band:
Blink at a 1Hz
Firmware On
Update
Locate AP Blink at 5Hz
Mode (Out of Phase with Activity LED)

2.9.2 WiNG 5.x LED States

System Booting
Radio Shutdown Administratively
or
LEDs Disabled
Radio Not Configured
or
Country-code not set
or WLAN not mapped to radio
Locate AP Mode
5 GHz Activity LED (Amber)
Task
2.4 GHz Activity LED (Green)
Off
If this radio band is enabled:
Blink at 5 second interval
If this radio band is disabled:
Off
If there is activity on this band:
Blink at a 1Hz
Off
Blink at 5Hz
(Out of Phase with Activity LED)
5 GHz Activity LED
(Amber)
Solid On (During start up
only)
Off
Blink (On 2 seconds, Off 2
seconds)
Off
2.4 GHz Activity LED
(Green)
Solid On (During start up
only)
Off
Blink (On 2 seconds, Off 2
seconds)
Blinking
17