Table of Contents
Advertisement
Fractal Audio Systems MFC-101 Manual
14.2 Firmware Update Error Codes
CODE
DESCRIPTION
1
Invalid Start Message
2
Unexpected Start Message
3
Invalid Base Address
4
Message Checksum Failed
5
Invalid Image Size
6
Invalid Data Message
7
Image Size Exceeded
8
Unexpected Data Message
9
Invalid Data Size
10
Flash Write Failed
11
Invalid End Message
12
Unexpected End Message
13
Truncated Image
14
Image Checksum Failed
15
EEPROM Write Failed
16
Message Too Small
17
Invalid Manufacturer ID
18
Invalid Model ID
Doc v2.15
SOLUTION
The SysEx start message was corrupted. Retry and if the problem persists, then
there is a problem with the image.
A SysEx start message was received after the update was started. This can be
caused by stopping the update in the middle and re-starting it. Reboot and start the
update again.
The firmware address specified in the image is invalid. The firmware image may be
corrupted.
A corrupted SysEx message was received. Reboot and start the update again. If the
problem persists, then the image may be corrupted.
The firmware size specified in the image is invalid. The firmware image may be
corrupted.
A corrupted SysEx image data message was received. Reboot and start the update
again. If the problem persists, then the image may be corrupted.
The image data received exceeds the size specified in SysEx start message. Reboot
and start the update again. If the problem persists, then the image may be
corrupted.
A SysEx image data message was received before the update was started. This can
be caused by stopping the update in the middle and re-starting it while SysEx data is
still being transmitted. Stop the SysEx transmit, reboot, and start the update again.
The image data size specified in the SysEx message does not match the expected
size. Reboot and start the update again. If the problem persists, then the image
may be corrupted.
The firmware image could not be written to flash. Retry the update and if the
problem persists, then the unit may have a hardware problem.
The SysEx end message was corrupted. Retry the update and if the problem
persists, then there is a problem with the image.
A SysEx end message was received before all of the image data was received (or
before a start message was received). This can be caused by stopping the update in
the middle and re-starting it while SysEx data is still being transmitted. Stop the
SysEx transmit, reboot, and start the update again.
A SysEx end message was received before the complete image data was received.
Retry the update and if the problem persists then there is a problem with the
image.
The checksum of the transmitted image data did not match the expected image
checksum. Retry the update and if the problem persists, then there is a problem
with the image.
The write of the firmware image size, version, or checksum to EEPROM failed. Retry
the update and if the problem persists, then there is a problem with the image.
The received SysEx message was not big enough to be a valid firmware update
message. Retry the update and if the problem persists, then there is a problem with
the image.
The image is for a device that is not manufactured by Fractal Audio Systems. Verify
that the correct firmware image is being transmitted. If the image is for the correct
device, then the image may be corrupted.
The image is not for an MFC-101. Verify that the correct firmware image is being
transmitted. If the image is for the correct device, then the image may be
corrupted. This can be caused by SysEx data for another device being sent to the
MFC-101 while it is in firmware update mode (for example, Tempo or Tuner data
from a connected Axe-Fx II).
APPENDIX
73
Advertisement
Table of Contents
