General Use Ia Switches; General Use Ia Switch Control Change Messages; Figure 5-2: Default Control Change Assignments For General Use Ia Switches - Fractal Audio MFC-101 Owner's Manual

Mark ii

Hide thumbs Also See for MFC-101:

Table of Contents

INTERNAL CCs

It is not possible to display the Axe-Fx Tuner on the MFC-101 when Axe-Fx Mode (p. 10) is turned off, though a CC#

message can still turn the tuner on and off in the same way it would work on any other MIDI Foot Controller.

A special function allows the tap footswitch to launch the Axe-Fx TUNER when held. See section 12.5.20.

5.2 General Use IA Switches

Instant Access Switches with their Axe-Fx functions set to "NONE" (or all IA switches when Axe-Fx mode is OFF)

offer a set of powerful general use MIDI commands. These General Use IA Switches can send the following types

of MIDI instructions when turned ON:



Up to 2 different MIDI Control Change messages with custom values (0–127).



Any one MIDI program change command on any channel.



Up to 16 bytes of freeform hexadecimal MIDI commands.

The OFF state can send:



The custom OFF values (0–127) for any CC#s sent by the ON action.



Any one MIDI program change command on any channel.



Another 16 bytes of freeform hexadecimal MIDI commands.

 REMEMBER: When AXE-FX MODE is ON, IA Switches with Axe-Fx functions assigned will ONLY send the MIDI commands for

their Axe-Fx assignments. See section 5.1, above.

The default assignments for the first Control Change message of each IA Switch are shown below. These are sent

with values of 127 for ON and 0 for OFF. All other IA switch settings are OFF by default.

Each IA Switch may be assigned up to 2 Control Change message numbers, each of which sends an ON value when

the switch is turned ON, and an OFF value when the switch is turned OFF.

Fractal Audio Systems MFC-101 Manual

Table of Contents