Table of Contents
Advertisement
MIDI MENU REFERENCE
12.4.3 Axe-Fx Preset Transmit Map
EDIT : MIDI : PAGE
(3x)
The Axe-Fx Preset Transmit ("Tx") Map is used to set up a custom map between MFC-101 presets and Axe-Fx presets. This
makes it possible for any MFC-101 preset to load any of the 384 presets from a connected Axe-Fx.
Axe-Fx TxMap 000->000
PARAMETER
Use the
footswitches to select between MFC Preset and Axe-Fx Preset.
The value "OFF" causes the current preset to send no change to the Axe-Fx, which allows you, for example, to change presets
on other components without switching the preset of a connected Axe-Fx.
12.4.4 MFC-101 MIDI Receive Channel
EDIT : MIDI : PAGE
(4x)
MFC-101 MIDI Receive ("Rx") Channel is used to specify the channel on which the MFC-101 will respond to MIDI program
change messages received at its MIDI IN port, if this feature is enabled (see below).
MIDI Rx Channel OFF
12.4.5 MFC-101 Receive Program Change
EDIT : MIDI : PAGE
(5x)
MFC-101 Receive ("Rx") Program Change is used to enable or disable incoming MIDI Program change response on the MFC-
101. Enabling this setting allows other devices to remote control the MFC-101 by loading its presets, which in turn send the
usual MIDI instructions to the MIDI OUT port as if they had been selected via footswitch.
RxProgramChange OFF
12.4.6 MFC-101 Program Change Map
EDIT : MIDI : PAGE
(6x)
The MFC-101 Program Change Map is used to create a custom relationship between incoming MIDI program change messages
and MFC-presets. This makes it possible to recall different MFC-101 presets depending on the MIDI program change number
received.
ProgChgMap 000->000
PARAMETER
footswitches move between Incoming Program Change and MFC Preset Number parameters.
NOTE: The range of MFC-101 Preset Numbers shown will be affected by the MFC-101 Display Offset (12.5.3).
NOTE: Receive Program Change (12.4.5) must be enabled for the MFC-101 to respond at all to Program Changes.
Fractal Audio Systems MFC-101 Manual
Advertisement
Table of Contents
