Fractal Audio Systems MFC-101 Manual
12.4 The MIDI Menu
The MIDI menu is used to set parameters which determine the MIDI output of the MFC-101.
12.4.0 MFC-101 Port
EDIT : MIDI
Axe-Fx MIDI Channel is used to set the channel on which the MFC-101 and Axe-Fx will communicate. For AXE-FX MODE to
work properly, this setting must match that of the Axe-Fx under I/O : MIDI : MIDI CHANNEL.
Use Port EXPANSION
12.4.1 Axe-Fx MIDI Channel
EDIT : MIDI : PAGE
(1x)
Axe-Fx MIDI Channel is used to set the channel on which the MFC-101 and Axe-Fx will communicate. For AXE-FX MODE to
work properly, this setting must match that of the Axe-Fx under I/O : MIDI : MIDI CHANNEL.
Axe-Fx MIDI Ch 01
12.4.2 Axe-Fx TotalSync
EDIT : MIDI : PAGE
(2x)
Axe-Fx TotalSync causes the MFC-101 to follow presets loaded via the front Panel of the Axe-Fx II or Axe-Edit.
TotalSync is designed for basic, default MFC/Axe-Fx II interactions only:
MFC-101 SONG and SET modes are not supported.
Custom MFC-101 Tx Map or Axe-Fx II preset remapping are not supported. (Presets loaded from the Axe-Fx II front
panel will load in their default MFC-101 bank/footswitch locations despite re-mapping.)
Axe-Fx Standard and Ultra are not supported.
Axe-Fx II firmware version 6.0 or better is required.
Axe-Fx TotalSync ON
Doc v2.15
MIDI MENU REFERENCE
51