Selecting A Port; Axe-Fx Midi Channel; Display Offset - Fractal Audio MFC-101 Owner's Manual

Mark ii

Hide thumbs Also See for MFC-101:

Table of Contents

Fractal Audio Systems MFC-101 Manual

3.2 Selecting a Port

Depending on whether your Axe-Fx is connected at the AXE-FX port or the MIDI port, you must set the

MFC-101 accordingly. (As of MFC firmware 2.0, the default is AXE-FX).

1. Press EDIT footswitch to enter EDIT MODE.

2. Press MIDI footswitch for the MIDI menu to arrive at the USE PORT screen:

Use Port Expansion

3. Press INCR or DECR to select "MIDI" or "EXPANSION" (the latter for the "Axe-Fx" port).

4. Press EXIT to return to PERFORMANCE MODE.

A factory-fresh MFC-101 expects the Axe-Fx to be on MIDI channel 1 (the unit's default setting). If you have

modified this setting in your Axe-Fx, you will need to make the same setting in the MFC-101 for AXE-FX MODE to

work properly:

1. Press EDIT footswitch to enter EDIT MODE.

2. Press MIDI footswitch to select the MIDI menu.

3. Press PAGE once to arrive at the Axe-Fx MIDI Channel Screen:

Axe-Fx MIDI Ch 01

4. Press the INCR or DECR footswitches to set the desired Midi Channel.

5. Press EXIT to return to PERFORMANCE MODE.

The Axe-Fx has a "Display Offset" feature which causes its presets to appear to be numbered from 001 instead of

from 000. If you have Display Offset set to "1" on your Axe-Fx, you need to make a setting change on the MFC-101:

1. Press EDIT footswitch to enter EDIT mode.

2. Press SETUP footswitch to select the SETUP menu.

3. Press PAGE 2x to get to the Axe-Fx Display Offset Screen:

Axe-Fx DisplayOfst 0

4. Press the INCR or DECR footswitch to set Display Offset as desired.

5. Press EXIT to return to PERFORMANCE MODE.

Doc v2.15

BASIC SETTINGS

Table of Contents