Table of Contents
Advertisement
not equipped
IEC60870-5-103 or DIGSI4/modem, electrical RS232
IEC60870-5-103, DIGSI4/modem or RTD box, electrical RS485
IEC60870-5-103, DIGSI4/Modem or RTD box, optical 820nm, ST connector
For further interface options, see Additional Information in the following
Additional information for additional ports (bottom side of device, rear, port B)
Profibus DP Slave, electrical RS485
Profibus DP Slave, 820 nm, optical double ring, ST connector
Modbus, electrical RS485
Modbus, optical 820 nm, ST connector
DNP3.0, electrical RS485
DNP3.0, optical 820 nm, ST connector
IEC 60870-5-103 Protocol, redundant, electrical RS485, RJ45 connector
IEC 61850, 100Mbit Ethernet electrical, double, RJ45 connector
IEC 61850 100 Mbit Ethernet optical, double, LC connector
DNP3 TCP, 100 Mbit Ethernet electrical, double, RJ45 connector
DNP3 TCP, 100 Mbit Ethernet optical, double, LC connector
PROFINET 100Mbit Ethernet electrical, double, RJ45 connector
PROFINET 100 Mbit Ethernet optical, double, LC connector
Converter
SIEMENS OLM
SIEMENS OLM
1)
The converter requires an operating voltage of 24 VDC. If the available operating voltage is > 24 VDC the
additional power supply 7XV5810–0BA00 is required.
not equipped
with Ethernet interface (DIGSI interface, RTD box connection, I/O unit connection, not IEC61850), RJ45 con-
nector
With fault recording
With fault recording, average values, min/max values
SIPROTEC, 7SK80, Manual
E50417-G1140-C344-A5, Release date 11.2012
Port B (bottom side of device, rear)
1)
1)
Port A (bottom side of device, front)
Measurement / Fault Recording
A.1 Ordering Information and Accessories
Order number
6GK1502–2CB10
6GK1502–3CB10
Appendix
Pos. 11
0
1
2
3
9
Supple-
mentary
+ L 0 A
+ L 0 B
+ L 0 D
+ L 0 E
+ L 0 G
+ L 0 H
+ L 0 P
+ L 0 R
+ L 0 S
+ L 2 R
+ L 2 S
+ L 3 R
+ L 3 S
Use
for single ring
for twin ring
Pos. 12
0
6
Pos. 13
1
3
419
Advertisement
Table of Contents
