Recalling A Program - Beckman Coulter Allegra X-12 Series Instructions For Use Manual

2
Enter run parameters (rotor, speed, time, temperature, acceleration/deceleration rate
settings).
a. Press
• If you entered an unacceptable parameter, an error message will be displayed.
b. (Press
3
When all parameters are entered, press
• The program is saved into memory and "
• The program number displayed will stop flashing.
• If any parameters are then modified, the program number will show a dash.
4
Press
ENTER/SAVE
NOTE
If the
without saving entered parameters into program memory.

Recalling a Program

1
Press
PROGRAM,
• The program parameters are displayed if
a. Press
2
Press
ENTER/SAVE
• The run starts, the green light next to the
NOTE
To begin a run,
wait more than 5 seconds, the
START
• The run will end automatically when the time display counts down to zero.
a. (Press
•
• A tone will sound when the rotor has come to a complete stop.
GX-IM-5AB
ENTER/SAVE.
and enter an acceptable value, then press the next run-parameter key.)
CE
and to run the programmed run.
START
PROGRAM
key is pressed while the program number is flashing, program mode is exited
then use the keypad or arrow keys to enter the number of the program.
to recall a program or press
ENTER/SAVE
and to begin the programmed run.
START
ENTER/SAVE
must always be the last key pressed before pressing
START
again to begin the run.
to terminate a run at any time.)
STOP
The green light next to the
ENTER/SAVE.
" appears on the display.
Program saved
was pressed.
ENTER/SAVE
to exit program mode.
PROGRAM
key flashes, and the rotor begins to spin.
START
key will not activate. If this happens, press
key will flash while the rotor decelerates.
STOP
3
Operation
Programmed Operation
START
. If you
ENTER/SAVE
and
3-9