Creating A New Program; Recalling A Program - Beckman Coulter Allegra X-14 sERIES Instructions For Use Manual

Creating a New Program

1
Press
PROGRAM
use, or one that you want to overwrite, and press
• The program number flashes.
2
Enter run parameters (rotor, speed, time, temperature, acceleration/deceleration rate
settings). Press
• If you entered an unacceptable parameter, an error message will be displayed.
a. (Press
3
When all parameters are entered, press
• The program is saved into memory and "
• The program number displayed will stop flashing.
• If any parameters are then modified, the program number will show a dash.
4
Press
ENTER/SAVE
NOTE
If the PROGRAM key is pressed while the program number is flashing, program mode is exited
without saving entered parameters into program memory.

Recalling a Program

1
Press
PROGRAM
a. Press
• The program parameters are displayed if
2
Press
ENTER/SAVE
• The run starts, the green light next to the
NOTE
To begin a run, ENTER/SAVE must always be the last key pressed before pressing START. If you
wait more than 5 seconds, the START key will not activate. If this happens, press ENTER/SAVE and
START again to begin the run.
• The run will end automatically when the time display counts down to zero.
(Press
a.
• The green light next to the
• A tone will sound when the rotor has come to a complete stop.
PN B07493AD
, then use the keypad or arrow keys to select a program number that is not in
.
ENTER/SAVE
and enter an acceptable value, then press the next run-parameter key.)
CE
and then
START
, then use the keypad or arrow keys to enter the number of the program.
to recall a program or press
ENTER/SAVE
and to begin the programmed run.
START
to terminate a run at any time.)
STOP
ENTER/SAVE
.
ENTER/SAVE
Program saved
to run the programmed run.
PROGRAM
was pressed.
ENTER/SAVE
key flashes, and the rotor begins to spin.
START
key will flash while the rotor decelerates.
STOP
Operation
Programmed Operation
.
" appears on the display.
to exit program mode.
2
2-9