GRAUPNER mc-16 Programming Manual page 92

Base setup model
Mod.name STARLET
Stick mode
module SP. 1
SP channel
Mod
Once again, press the central SET button of the right-
hand four-way button to conclude the Select process.
The lines of the "Receiver output" and "Range test" op-
tions (described below) are also suppressed, as are all
the HoTT-specific displays in the base display; "SP." is
also superimposed instead of "HoTT":
STARLET Stp
#02 Flt
«nor mal
4.1V
K78
0:12h
"Mode" column
Base setup model
Mod.name STARLET
Stick mode
module SP. 1
SP channel
Mod
In this column you select the transmission mode of the
external RF module:
• Mode "1": 2-channel hopping
• Mode "2": x-channel hopping
92 Program description - Base setup models | Helicopter models
"BIND" column
1
Mod.name
BIND
Stick mode
6
module
BD SP channel
The "BIND" column in the right-hand column can be
used to initiate the "Bind" process of the non-Graupner
system – the transmitter's RF section must be
switched off when the transmitter is first switched
on.
Important notes:
0:00
• The output voltage of the DATA socket
0:00
is around 5 V, and must be reduced to
»
SP the power supply voltage generally re-
quired by external digital RF modules (3 to
max. 3.3 V). This is accomplished using the cir-
cuit which is shown here in diagrammatic
form:
DATA S
Vcc IN = 5 V
1
DATA +
BIND
22µF/6.3 V
6
BD
DATA -
• Servo travels must be limited to max. 128 %.
SP channels
Note:
This menu line is suppressed in the "Module"
line if you select "HoTT" or "EXT.".
If necessary, use the Select buttons  of the left or
right-hand four-way button to move to the "SP chan-
nels" line, then briefly press the central
Base setup model
STARLET
1
SP. 1 BIND
6
Mod BD
125000 baud signal
Vcc OUT = 3 ... 3.3 V
Vcc
Low Drop
Voltage
SP.-MODULE
Regulator
22µF/6.3 V
with
GND
digital input signal
GND
SET button of
the right-hand four-way button to activate the Value
window:
Base setup model
Mod.name STARLET
Stick mode
module SP. 1 BIND
SP channel
You can now select "6" or "8" channels using the right-
hand Select buttons. The procedure is concluded by
again pressing the central SET button of the right-hand
four-way button.
At the transmitter this selection only affects the number
of control channels transferred to the external RF mod-
ule via the DATA socket. If you choose "6", then these
are control channels 1 ... 6; if you choose "8", these
are channels 1 ... 8.
Simultaneously pressing the  or  buttons of the
right-hand four-way button (CLEAR) returns the dis-
play to "6".
EXT. PPM signal
Note:
This menu line is suppressed in the "Module"
line if you select "HoTT".
Base setup model
Mod.name STARLET
Stick mode
module EXT. PPM10
EXT.PPM sig.
SEL
Some RF modules which can be connected to the
DSC connector require an inverted input signal. Be
sure to follow the respective module's installation in-
structions for this.
1
6
SEL
1
normal
SEL