GRAUPNER mc-16 Programming Manual page 215

When using this mixer, however, the tail
type MUST be entered as "normal" on the
"Model type" menu.
Tip:
All settings can be checked directly in the
»Servo display« menu, which can be
accessed from almost any other menu by
simultaneously tapping the  keys on the left
four-way button.
Example:
Model with two rudders, with differential travel and
outward movement (e. g. swept-back flying wing):
Dual mixer
Mixer1 8 RU
Mixer2 ?? ??
Mixer3 ?? ??
Mixer4 ?? ??
Typ zu
When a rudder command is given, the second servo
connected to output 8 follows suit. (With this type of
programming, differential travel can be configured
for the rudders.) In this case, too, trim from the rud-
der stick affects both servos. If the rudders are also
required to deflect outwards when the airbrakes are
activated, then you should assign the C1 stick (trans-
mitter control 1) to input 8 on the »Control adjust«"
menu. Afterwards, change to the "Offset" column then
modify the offset value until both rudders are again in
their neutral positions. It may be necessary to "play" a
bit with the offset and travel adjustments.
+75%
0%
0%
0%
Diff.
Program description - Dual mixers 215