Voice Trigger - GRAUPNER mc-16 Programming Manual

VOICE TRIGGER

After selection of the desired menu line with the 
selection keys of the left or right four-way button ...
TELEMETRY
TEL.RCV. RCV CH1
SETTING & DATA VIEW
SENSOR SELECT
RF STATUS VIEW
VOICE TRIGGER
... and a subsequent tap on the centre
right four-way button will open the selected sub-menu.
Firmware version V1101 and lower
VOICE TRIGGER
REPEAT 10SEC
TRIG
VARIO
TRANSMITTER
RECEIVER
GENERAL MODULE
ELECTRIC AIR.MOD
VARIO MODULE
GPS
AIR ESC
Note:
• Independently by the firmware version
the sensors displayed by your transmitter
here vary according to the information
you have entered in the "SELECT SENSOR"
sub-menu; see page 250.
• The screen-shot above shows the maximum
number of options, corresponding to "all sensors
selected".
252 Program description - Telemetry
Firmware version V1102 and higher
VOICE TRIGGER
REPEAT
TRIG
VARIO
TRANSMITTER
RECEIVER
GPS
REPEAT
SET key of the
VOICE TRIGGER
REPEAT
TRIG
VARIO
TRANSMITTER
RECEIVER
–––
–––
–––
In order to be able to start the voice output through the
headphone connection, at the very least the "REPEAT"
line must be assigned to a switch. The takes place as
described in the section "Physical control, switch and
control switch assignments" on page 60:
VOICE TRIGGER
REPEAT
M o v e d e s i r e d s w i t c h
TRIG
t o O N p o s i t i o n
VARIO
TRANSMITTER
( e x t . s w i t c h : S E T )
RECEIVER
VOICE TRIGGER
REPEAT
TRIG
VARIO
TRANSMITTER
RECEIVER
With this switch you can have the last respective voice
trigger repeated for the duration of the time set to the
left of the switch, as long as the assigned switch is
closed.
Simultaneously pressing the Select buttons  or 
of the right-hand four-way button (CLEAR) resets the
10SEC –––
–––
time value to "1 SEC.".
AUTO
–––
TRIG
With a switch assigned to this line, preferably a push-
button, switch the selected voice messages in rotation
on to the next voice message for the below-described
"TRANSMITTER", "RECEIVER" and "SENSOR" op-
tions.
10SEC –––
–––
AUTO
–––
VARIO
Firmware version V1101 and lower
If the "VARIO MODULE" line is activated (
»SENSOR SELECT« sub-menu, as described on
10SEC –––
page 250, a switch assigned to one of these lines
–––
can be used to call up vario-specific voice messages
–––
for the headset connection which are completely inde-
pendent of other voice messages, i. e. voice messages
triggered by altitude changes, such as the message
"slowly ascend/descend":
10SEC 7
–––
AUTO –––
VOICE TRIGGER
REPEAT 5SEC 7
TRIG 8
VARIO AUTO –––
TRANSMITTER
RECEIVER
) in the
VOICE TRIGGER
REPEAT 5SEC 7
TRIG 8
VARIO 15
TRANSMITTER
RECEIVER