GRAUPNER mc-16 Programming Manual page 258

Multichannel
MC1 OFF 5CH MUL4CH
MC2 OFF 6CH MUL8CH
SET SEL SEL
Afterward, use the right arrow symbol at the bottom
line's right end to switch over to the second page of
settings for the »Multichannel« menu. On this second
page you can now enter the individual settings sepa-
rately for "MC1" (Multichannel 1" ...
Multichannel 1
INPUT1 fr –––
INPUT2 fr –––
INPUT3 fr –––
INPUT4 fr –––
SEL
... and "MC2" (Multichannel 2) ...
Multichannel 2
INPUT1 fr –––
INPUT2 fr –––
INPUT3 fr –––
INPUT4 fr –––
INPUT5 fr –––
INPUT6 fr –––
INPUT7 fr –––
INPUT8 fr –––
SEL
258 Program description - Multichannel
Column 2 "Control"
INPUT1
INPUT2
INPUT3
INPUT4
Use the arrow keys to move to the column over SEL.
After completing the activation of transmitter control
assignment by tapping the centre
four-way button, the message shown below will appear
in the display:
0%
0%
INPUT1
0%
INPUT2
0%
INPUT3
offset
INPUT4
Now operate the transmitter control you wish to use:
the information window closes, and instead the Value
0%
field displays the name of the transmitter control you
0%
have chosen.
0%
0%
Note:
0%
If you are using the Nautic-Expert switch
0%
module, No. 4159, any proportional controls
0%
you assign act like switches when close to
0%
their end-points.
offset
Multichannel 1
fr ––– 0%
fr ––– 0%
fr ––– 0%
fr ––– 0%
SEL offset
SET key of the right
Multichannel 1
fr 0%
–––
Move desired
fr ––– 0%
control adj.
fr ––– 0%
fr
––– 0%
SEL offset
Column 3 "Switch"
Multichannel 1
INPUT1 fr –––
M o v e d e s i r e d s w i t c h
INPUT2 fr –––
t o O N p o s i t i o n
INPUT3 fr –––
( e x t . s w i t c h : S E T )
INPUT4 fr –––
SEL
This column is used to assign each of the inputs used,
1 through 8 (maximum), to any switch available on the
transmitter. These assignments are done as described
in the section "Physical control, switch and control
switch assignments" on page 60:
Any controls which were previously assigned in the
second column will be erased. In this case, instead of
SEL, the switch symbol will be displayed at the
bottom of the 2nd column such that now a second
"normal" switch, or even a transmitter control switch,
logical switch, ... can be assigned as needed from the
group of "expanded switches". In general it is sufficient
to assign a simple switch or transmitter control.
Multichannel 1
INPUT1 ––– 2
INPUT2 fr –––
INPUT3 fr –––
INPUT4 fr –––
Erasing transmitter controls or switches
With transmitter control / switch assignment active,
simultaneously pressing the  or  buttons of the
right-hand four-way button (CLEAR) – see screen-shots
above – resets the corresponding input to "fr" and "---".
0%
0%
0%
0%
offset
0%
0%
0%
0%
offset