GRAUPNER mc-16 Programming Manual page 74

will be replaced during the copy process with a til-
de (~).
• A model fi le already on the memory having the
same name as the fi le to be copied will be over-
written without warning.
Importing from SD card
Use the  selection keys of the left or right four-way
button to select the "Import from SD" sub-menu then
tap on the SET key.
Erase model
Copy model–>model
SWITCHING RF OFF
Expor t zu SD
Impor t von SD
OK
Copy flight phase
If the message shown above should appear, the trans-
mitter's RF module is still active.
You can interrupt the process by pressing the central
ESC button of the left-hand four-way button.
Pressing the SET button of the right-hand four-way
button resumes the process. However, if the receiving
system is switched on, you should switch it off before
doing this.
Select the model to be imported from the SD memory
card with the  selection keys of the left or right four-
way button:
impor t from SD-CARD:
ALPINA 11/03/10
EXTRA 11/03/11
COBRA 11/03/11
BELL47G 11/03/12
05 frei
 
74 Program description - Copy / Erase
Note:
The export date posted at the right end of
each model name line is represented in the
format "year/month/day".
After another tap on the
button, the "import from SD-CARD" window will ap-
pear. Now the destination memory location can be
selected with the  selection keys of the left or right
four-way button then confi rmed with a tap on the
key, or the process can be canceled with a tap on the
ESC key. A memory location which is already occupied
=>
can be overwritten.
=>
=>
impor t to model:
=> =>
01
=> =>
02
03
04
05
After confi rming the selected model memory with a tap
on the SET key, a confi rmation request will appear:
modell
03
impor t ?
A NO response will cancel the process and return the
screen to the originating screen. If the  YES response
is selected and confi rmed with a tap on the
then the selected source model will be imported into
the selected destination model memory.
Notes:
• If the message ...
SET key of the right four-way
SET
GRAUBELE MR12
ULTIMATE GR12
MR12
STARLET
BELL47G M–––
free
 
ULTIMATE
free
 
NO YES
SET key
SD-CARD
INSERT
OK
... appears instead of a screen for model
selection, there is no SD card in the trans-
mitter's card slot, see page 26.
• If a memory specifi cally bound and in the mean-
time on the SD card, for example, for backup pur-
poses, the same model is loaded back into the
original model memory from the same transmitter,
the receiver existing binding is retained.
On the other hand, the same model is copied to a
different model memory, or even in another chan-
nel, the affected receiver MUST be re-bound.
• In addition to model data, binding data is also im-
ported by this process. This means that a receiver
system which was/is bound to the original model
memory can also be operated in the SAME trans-
mitter by its copy without establishing the bond
again.
In principle the model memories of the mx-20 and
•
mc-20 transmitters are compatible, BUT:
If you wish to carry out an "Import from SD card" in
the other transmitter you must fi rst copy or move
the model memory concerned to the appropriate
folder on a PC. For example: from \\Models\mc-20
to \\Models\mx-20, or vice versa.
C A U T I O N :
After you have carried out an "Import from
SD card" it is absolutely essential to check
all the model functions with great care.
Note also that the transmitter control and switch
functions may need to be adjusted to suit the new
transmitter.