GRAUPNER mc-16 Programming Manual page 73

... then, following the change into the "Copy to model"
window caused by another tap on the
right four-way button, the destination memory can be
selected with the  selection keys of the left or right
four-way button. Yet another tap on the
then confi rm the copy process or a tap on
will cause the copy to be cancelled. A memory location
which is already occupied can be overwritten.
Copy to model:
01 GRAUBELE
02 ULTIMATE
03 STARLET
04 BELL47G
05 free
 
After confi rming the selected model memory with a tap
on the SET key, a confi rmation request will appear:
Modell really
01 ULTIMATE
03 free

to be copied?
NO YES
A NO response will cancel the process and return
the screen to the originating screen. If the  YES
response is selected and confi rmed with a tap on the
SET key then the selected source model will be copied
into the selected model memory destination.
Note:
• If a memory specifi cally bound model
copied to any other model memory from
the same transmitter, the receiver in the
destination memory is to rebind.
• When a station is specifi cally bound model cop-
ied to any other model memory from the same
transmitter, the receiver existing bond is retained.
Exporting to SD card
SET key of the
Use the  selection keys of the left or right four-way
button to select the "Export to SD" sub-menu.
SET key will
ESC key
MR12
... and tap on the
GR12
MR12 Note:
M–––
If this message appears, there is an active telemetry
link to a receiving system. Turn off this and wait until
the display is briefl y automatically hidden afterward.
Choose the model to be exported with the  selec-

tion keys of the left or right four-way button ...
01
02
03
04
05
After confi rming the selected model memory with a tap
on the SET key, a confi rmation request will appear:
Erase model =>
=>
Copy model–>model
=>
Expor t to SD
=> =>
Impor t from SD
=> =>
Copy flight phase
SET key,
Attention!
Switch-OFF
the Receiver first!
expor t to SD-CARD:
GRAUBELE MR12
ULTIMATE GR12
STARLET MR12
BELL47G M–––
frei
 
modell
01 ULTIMATE
SD-CARD
expor t ?
NO YES
A NO response will cancel the process and return the
screen to the originating screen. If the  YES response
is selected then confi rmed with a tap on the
the selected model will be copied to the SD card.
Notes:
• Should the notice ...
SD-CARD
INSERT
OK
... appears instead of a screen for model
selection, there is no SD card in the trans-
mitter's card slot, see page 26.
• In addition to model data, binding data is also cop-
ied by this process. This means that a receiver
system which was/is bound to the original model
memory can also be operated in the SAME trans-
mitter by its copy without establishing the bond
again.
• An exported fi xed-wing model will be stored on
the memory card in the \\Models\mc-16 respec-
tively \\Models\mc-20 folder with a fi lename for-
mat of "aModelname.mdl" and a helicopter model
with a fi lename format of "hModelname.mdl". On
the other hand, if a "nameless" model is export-
ed, its data will be stored on the memory card un-
der "aNo Name.mdl" or "hNoName.mdl", as appro-
priate.
• Some special characters that can be used in mod-
el names are subject to specifi c restrictions asso-
ciated with the FAT or FAT32 fi le system used by
the memory cards and these special characters
Program description - Copy / Erase
SET key,
73