GRAUPNER mc-16 Programming Manual page 45

VARIO
RX–S QUA: 100%
RX–S ST : 100% RECEIVER
RX–dBm: GENERAL 33dBm
TX–dBm: ELECT. AIR 33dBm
V–PACK: VARIO 10ms
GPS
RX–SPG.:4.8 AIR ESC
CH OUTPUT TYPE:ONCE
m/1s H
0.0
m/3s ALT
0.0 0
m/10s
0.0 L
If attached to the receiver, this display will depict the
data acquired by a Vario module, No. 33601.
The displayed items are as follows:
Value Explanation
ALT current altitude
RXSQ Signal quality of the signal received by
the receiver in %, see page 238.
MAX the preset maximum altitude limit relative
to starting location at which, when
exceeded, will cause an audible warning
to be sounded
MIN the preset minimum altitude limit relative
to the starting location at which, when
underrun, will cause an audible warning
to be sounded
m/1s m/1 s ascent/decent rate
m/3s m/3 s ascent/decent rate
m/10s m/10 s ascent/decent rate
Micro-copter display
TMP
This screen displays the data generated by a HoTT-
RXSQ
compatible micro-copter. Key, reading from top left to
0
bottom right:
MAX
Value Explanation
0m
V Actual voltage
MIN
0m "0:00" Period switched on
mAh Battery capacity consumed
"0" Position number of the satellites
km/h Speed over ground, according to GPS
system
Alt Actual altitude
Dir Direction of movement
I Actual current
m Distance from take-off point, according
to GPS system
° Position in degrees relative to take-off
point, according to GPS system
Any messages from the micro-copter sensor are dis-
played in the bottom line of the screen, which is empty
in the screen-shot shown above.
0.0V Alt: 0m
0:00 Dir: 0°
0mAh I: 0A
0 0m
0km/h 0°
Vario
0.0
If attached, this display will depict altitude relative to
location or starting location (in m) as well as the current
rate of ascent/decent (in m/s) from data acquired by a
Vario module (No. 33601).
Text display
If the corresponding sensors are available, text from
them showing 2 x 10 or 3 x 7 characters can be super-
imposed in the two following displays when required:
Transmitter description - Telemetry data display
0
m
m
s
45