Warning And Note Symbols - GRAUPNER mc-16 Programming Manual

Model type: "1AIL 1FL" ..................................... 170
Model type: "2AIL"............................................. 172
Model type: "2/4AIL 1/2/4FL" ........................... 174
(Max. 2 ailerons and 2 flaps with the
standard 8-channel mc-16 transmitter)
»Helicopter mixer« ..............................
Fine-tuning the throttle and collective
pitch curve ........................................................ 195
Autorotation setting ........................................... 198
General notes on freely programmable mixers ........ 200
»Free mixers« ......................................
Linear mixers ..................................................... 205
Curve mixers ..................................................... 207
Examples .......................................................... 209
»Mix active / phase« ............................
»Mix-only channel« .............................
»Dual mixer« ........................................
»Swashplate mixer« ............................
»Fail safe« ............................................
»Teacher/Pupil« ...................................
Connection schematic ....................................... 221
Wireless HoTT system ....................................... 222
»Tx. output swap« ...............................
»Profi trim«
Winged model ................................................... 228
Helicopter model ............................................... 230
»Trim memory«
Winged model ................................................... 232
Helicopter model ............................................... 234
»Telemetry« .........................................
Important notices: ............................................. 236
SETTINGS & DATAVIEW .................................... 238
Satellite mode .............................................. 247
Sensor(s) ...................................................... 248
Sensor (select) ................................................... 250
RF STATUS VIEW .............................................. 251
VOICE TRIGGER ............................................... 252
»Channel Sequencer« .........................
»Multichannel« ....................................
»Ring limiter« .......................................
»MP3 player« .......................................
»Basic settings, transmitter« .............
»Servo display« ...................................
»Servo test« .........................................
»Code lock« .........................................
  184 »Info Display« ......................................
Programming examples
Introduction. ........................................................... 280
Winged model
First steps ......................................................... 282
201
 
Incorporating an electric drive ............................ 289
C1 joystick switchover between:
Electric motor and butterfly ........................... 292
Electric motor and airbrake ........................... 295
211
 
Timer confirmation with control or switch ........... 296
212
 
Parallel operating servos .................................... 298
214
 
Using flight phases
  216
Example 1 .................................................... 300
  216
Example 2 .................................................... 304
  218
Control of temporal processes ........................... 310
Delta and flying wing.......................................... 312
F3A model ......................................................... 316
  226
Helicopter models .................................................. 320
 
Appendix
FCC Information ..................................................... 332
Declaration of Conformity ....................................... 333
 
Warranty Certificate ................................................ 334
  236
254
 
257
 
  260

Warning and note symbols

and their meaning
264 WARNING:
 
  266
This symbol highlights the adjacent or following
  274
instructions, which absolutely must be adhered
  275
to by the user! Any disregard of these instruc-
  276
tions, can affect the safe operation and safety
278
  of the operator as well as bystanders.
ATTENTION:
This symbol highlights the adjacent or following
instructions which must be observed by the
user! Any disregard of these instructions can
lead to damage of any kind, loss of guarantee
and so on.
This symbol without specific headline empha-
sizes the adjacent or following notes and tips
which should be strictly observed by the user!
Any disregard of these instructions and tips
can result in damage of any kind.
This symbol highlights hints and tips of all
kinds, which should be observed by the user.
This symbol highlights information about clean-
ing the device, which should be strictly ob-
served by the operator in order to ensure a
long life of the device.
Table of contents 3